Menu List - Canon Color imageCLASS MF9170c Service Manual

Chapter 15

15.1.3 Menu List

imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
Maintenance
Special management function
code
27767 High-resisting paper mode
27267 4mil transparency mode
23866 Calcareous paper mode
25407 Thin/rough paper mode
47267 High-humidity transparency mode Transparency
47667 Re-transfer prevention mode
34691 Color displacement correction
mode
14682 Foggy image prevention mode
25200 Transparency permeability
correction mode
53649 Monochrome mode engage mode Monochrome
35607 Hot offset prevention mode
65676 Leading edge margin switch
(enlarge)
65677 Leading edge margin switch
(reduce)
68676 Image position correction mode
(toward right)
68677 Image position correction mode
(toward left)
25607 Printing mode setting switch
15-2
T-15-1
Applicable Setting value
mode (*default)
All modes OFF * Lower the final output value of transfer bias by 250V.
ON (Only if the high-humidity transparency mode or high-humidity glossy film
mode is not specified.)
Transparency OFF * Lower the final output value of transfer bias by 500V.
ON (Only if the high-humidity transparency mode, high-humidity glossy paper
mode or high-resisting paper mode is not specified.)
All modes OFF * Apply the maximum attraction bias regardless of environment. Since there is
ON no attraction paper resistor result, set the transfer bias in accordance with the
environment.
Thin paper OFF * Change the process speed by 4/5 speed. Use the temperature control table for
ON thin/rough paper (for thin paper only).
Process speed is not changed but the temperature control table is changed (for
plain or thick paper 2 only).
OFF * Lower the final output value of transfer bias by 100V (for transparency only).
ON
All modes OFF * Lower the transfer bias of yellow and black according to the environment.
ON (Only if the high-humidity transparency mode, high-humidity glossy film
mode, high-resisting paper mode or 4mil transparency mode is not specified.)
Color mode OFF * Pre-rotation is extended by 10 sec and also paper interval is extended by one
ON and half-round when printing.
All modes OFF * Pre-exposure is turned OFF. Transfer bias is not applied as a countermeasure
ON against the trailing edge toner splash.
Transparency OFF * Specify the control temperature at 180 deg C and make an idle rotation of the
ON fixing assembly for 45 sec at initial rotation.
OFF * Print in ETB full-engaged mode.
mode ON
All modes OFF * Lower the control temperature by 10 deg C without exception.
ON
All modes OFF * Enlarge the leading edge margin by 2 mm. When the leading edge margin is
ON already set to small beforehand, the margin will be standard.
All modes OFF * Reduce the leading edge margin by 2 mm. When the leading edge margin is
ON already set to large beforehand, the margin will be standard.
All modes OFF * Use this when the image is displaced to the left. When this is specified, image
ON is moved to the right by 2 mm. When the image position correction mode
(toward left) is already set, margin will be standard.
All modes OFF * Use this when the image is displaced to the right. When this is specified, image
ON is moved to the left by 2 mm. When the image position correction mode
(toward right) is already set, margin will be standard.
For overseas OFF * To prevent hot offset at outside Japan, change the printing mode of [plain
models (plain ON paper] from [Normal mode] to [Light mode].
paper mode)
Control details
0020-4718