Film Shaft Brake; Core Adapters; Center Core Support; Rewind Brake - GBC Falcon 60+ Operation Manual

60+ (-1)
FALCON
N. FILM SHAFT BRAKE: (Figure 14) Used to apply resis-
tance to the film shaft. One for the upper unwind and one
for each of the lower unwinds.
To increase film shaft brake, turn the film shaft brake dial
clockwise. Counter clockwise will decrease film shaft
brake tension.
O. CORE ADAPTERS: (Figure 14) Hold and lock the rolls
of film on the shafts to prevent side to side shifting.
P. CENTER CORE SUPPORT: (Figure 14) Supports
the center of the film cores when placed onto the unwind
shafts.
Q. REWIND BRAKE: (Figure 15) Located on the right
side from the front operating position.
Turn in a forward roller direction to increase rewind brake
tension. Reverse roller direction will decrease rewind
brake tension.
R. MAIN ROLLER CRANK HANDLE: (Figure 15) Used
to raise or lower the upper main roller. Turning the handle
clockwise will lower the roller. Counterclockwise will raise
the roller.
NOTE: You can not raise or lower the main roller if
the feed table is in the tilted position.
S. PULL ROLLER CRANK HANDLE: (Figure 15) Used
to raise or lower the upper pull roller. Turning the handle
clockwise will raise the roller. Counterclockwise will lower
the roller.
T. COOLING FANS: Assist in the cooling process by
pushing unheated air onto the web material as it exits the
heated rollers. This feature can be controlled from the
control panel (Not Shown).
U. CLUTCH: (Figure 16) Used to increase or decrease
pull roller clutch tension. Clockwise rotation will increase
clutch tension while counterclockwise rotation decreases
clutch tension.
Page 20
CE
(O)
(P)
(O)
Fig 14
(Q)
(S)
Fig 15
(U)
NORMAL/SLOW
SPEED SWITCH
Fig 16
©2004 General Binding Corporation
Operations Manual
(O)
(P)
(N)
(N)
(R)
(V)