Safety Instructions - GBC 5031TS ROLL Instruction Manual

GBC 5031TS
IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AS WELL AS THE SAFETY OF
OTHERS IS IMPORTANT
INSTRUCTION MANUAL AND ON THE PRODUCT,
YOU WILL FIND IMPORTANT SAFETY MESSAGES
REGARDING THE PRODUCT.
MESSAGES CAREFULLY. READ ALL OF THE
INSTRUCTIONS AND SAVE THESE INSTRUCTIONS
FOR LATER USE.
THE SAFETY ALERT SYMBOL PRECEDES
EACH SAFETY
INSTRUCTION
INDICATES A
SAFETY HAZARD TO YOU OR OTHERS. THE
FOLLOWING WARNINGS ARE FOUND UPON
THIS PRODUCT.
ADVERTENCIA
Attention
Riesgo de choque Risque de
eléctrico Secousseélectrique.
No abra: Ne pas ouvrir.
Adentro no hay Pas de pièces
piezas reparables réparables par
por el usuario. l'utilisateur.
Mantenimiento Entretien
solamente por seulement par
personal calificado personnel qualifié.
THIS SAFETY MESSAGE MEANS THAT YOU COULD
BE SERIOUSLY HURT OR KILLED IF YOU OPEN THE
PRODUCT AND EXPOSE
HAZARDOUS VOLTAGE.
ADVERTENCIA Attention
RODILLOS ROULEAUX
CALIENTES. CHAUDS.
PUNTO DE POINT DE
PINCHAMIENTO. PINCEMENT.
Mantener manos y Tenir mains et
ropa a distancia. vêtements à
l'écart.
THIS SAFETY MESSAGE MEANS THAT YOU COULD
BE BURNED AND YOUR FINGERS COULD BE
TRAPPED AND CRUSHED IN THE HOT ROLLERS.
CLOTHING, JEWELRY AND LONG HAIR COULD BE
CAUGHT IN THE ROLLERS AND PULL YOU INTO
THEM.
ADVERTENCIA Attention
NAVAJA FILOSA. LAME
COUPANTE.
Mantener manos y
dedos a distancia. Tenir mains et
doigts à l'écart.
THIS SAFETY MESSAGE MEANS THAT YOU COULD
CUT YOURSELF IF YOU ARE NOT CAREFUL.
WARNING: THIS SAFETY ALERT SYMBOL
PRECEDES EACH SAFETY MESSAGE IN
THIS INSTRUCTION MANUAL. THE SYMBOL
INDICATES A
SAFETY HAZARD TO YOU OR OTHERS.
WARNING: DO NOT ATTEMPT TO SERVICE
OR REPAIR 5031TS LAMINATOR.
WARNING: DO
LAMINATOR TO AN ELECTRICAL SUPPLY
OR ATTEMPT
LAMINATOR UNTIL YOU HAVE COMPLETELY READ
THESE INSTRUCTIONS.
INSTRUCTIONS IN A CONVENIENT LOCATION FOR
FUTURE REFERENCE.
© 2006 General Binding Corporation
TO GBC. IN THIS
READ THESE
MESSAGE IN THIS
MANUAL. THE SYMBOL
POTENTIAL PERSONAL
Avertissement
Electrical shock
hazard.
Do not open.
No user serviceable
parts inside.
Refer servicing to
qualified service
personnel.
YOURSELF
Avertissement
HOT ROLLS.
PINCH POINT.
Keep hands and
clothing away.
Avertissement
SHARP BLADE.
Keep hands and
clothing away.
POTENTAL PERSONAL
NOT CONNECT THE
TO OPERATE THE
MAINTAIN THESE
IMPORTANT SAFEGUARDS
WARNING: TO GUARD AGAINST INJURY
THE FOLLOWING SAFETY PRECAUTIONS
MUST BE OBSERVED IN INSTALLATION
AND USE OF THE LAMINATOR.
General:
Keep hands, long hair, loose clothing, and articles such as
necklaces or ties away from the front of the heat and pull
rollers to avoid entanglement and entrapment.
The heat rollers can reach temperatures over 300
o
(150 C). Avoid contact with the heat rollers during operation
or shortly after power has been removed from the
laminator.
Keep hands and fingers away from the path of the sharp
film cutter blade located at the film exit.
Do not use the laminator for other than its intended
purpose.
Avoid moving the Laminator on uneven floor surfaces.
Never tilt the laminator.
Do not defeat or remove electrical and mechanical safety
equipment such as interlocks, shields and guards.
Do not insert objects unsuitable for laminating or expose
the equipment to liquids.
TO
Electrical:
The Laminator should be connected only to a source of
power as indicated in these instructions and on the serial
plate located on the rear of the laminator. Contact an
electrician should the attachment plug provided with the
Laminator not match the receptacles at your location.
WARNING:
LOCATED NEAR THE EQUIPMENT AND EASILY
ACCESSIBLE.
Do not operate the Laminator with a damaged power
supply cord or attachment plug, upon occurrence of a
malfunction, or after the laminator has been damaged.
Contact GBC's Technical Service Department or your
dealer/distributor for assistance.
Service:
Perform only the routine maintenance procedures referred
to in these instructions
WARNING: DO NOT ATTEMPT TO SERVICE OR
REPAIR THE LAMINATOR
Disconnect the plug from the receptacle and contact GBC's
Technical Department or your dealer/distributor when one
or more of the following has occurred.
• The power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the laminator.
• The laminator is malfunctioning after being
mishandled.
• The laminator does not operate as described in these
instructions.
OPERATION MANUAL
THE RECEPTACLE MUST
o
F
BE
3