Features/Accessories Guide; Emergency Stop; Front Safety Shield Interlock Latches; Front Safety Shield - GBC 620OS Installation And Operating Manual

GBC 620os
FEATURES/ACCESORIES GUIDE
Figure 1
Fig ure 2
Fig e 3
Figure 4
© 2007 General Binding Corporation
Refer to the following pages for detailed
ur
information on the Features.
EMERGENCY STOP BUTTONS
(Fig. 1– Item A)
There are two EMERGENCY STOPS on the laminator.
One is located at the rear of the machine and the other is
located on the front.
To engage, press any EMERGENCY STOP to stop the
roller mov ement. To disengage, turn the EMERGENCY
STOP clockwise after the emergency condition has been
resolved.

FRONT SAFETY SHIELD INTERLOCK LATCHES

(Fig.1-Item B)
The Front Safety Shield Interlock L
the Front Safety Shield is in
engaged, the m achine will not o

FRONT SAFETY SHIELD

( Fig.2-ItemC)
The Front S afety Shield
entrapment, and inadvertent contact with the Heat Roller.

REWINDER

( Fig.2-ItemD)
The Rewinder is used to take up any film that is being slit
via the In-Line Slitters.

FEED GATE

(Fig.2-ItemE)
T he Feed Gate controls the images entering t
will activate ac cording to the paper size selected on the
display, and giv e an even and accurate overlap.

FEED BELTS

( Fig.2-ItemF)
The Feed Belts move the images into the Feed Gate and
t hen into the n ip.

TABLE SIDE GUIDES

(Fig.2-Ite mG)
The Table Side Guides are adjustable to ensure a
feeding.

BURST ROLLER GAP ADJUSTMENT KNOB

(Fig.3-ItemH)
The Burst Roller Gap Knob raises and lowers the Burst
R oller. Depending on the media
operator can raise or lower the Burst Roller
Burst or Snapp ing of the images.

DECURLING ADJUSTMENT KNOB

(Fig.3-ItemI)
The Decurling Adjustment Knob is used in conjunction
with the film shaft brake to increase or decrease the a
of curl desired by the oper
located betwee n the Main Ro

FEED INDICATOR LED

(Fig.4-ItemJ)
The Feed Indicator LED will indica
can be placed on the F eed Table. Sheets should not be
placed until the LED is illum

FEED GATE STOPS

(Fig.4-ItemK)
The Feed Gate Stops can be adjusted up, down, and left to
right to accommodate various media paper thicknesses.
Operation Manual
atches ensures that
serted properly and if not
perate.
prevents entanglement,
he Nip. It
ccurate
and film being used, the
to assist in the
mount
ator. The Decurling Bar is
lls and the Pull Rolls.
te when the next sheet
inated.
Page 9