Sanitising Mixers And Food Circuits For The First Time - LAVAZZA Magystra LB 2600 INT Installation And Maintenance Manual

EN
Using a water softener filter (optional accessory)
improves water quality and prolongs the life of
the device. To insert the filter follow the instruc-
tions sheet attached to it. Read carefully the filter
instructions sheet and observe the replacement in-
structions.
At the end of assembly and final testing, the water
used for testing is discharged from the machine. At
the first power-on, all circuits must be filled in be-
fore any other action, the vending machine will load
water from the inner tank.
The vending machine executes a diagnostic cycle
for loading water and rinsing. During this phase, the
display shows.
INSTALLATION
END INSTALLATION
Wait for water to come out of the dispensing noz-
zles for some seconds. The flow will automatically
stop.
Ca . 120 cc . of hot water will be dispensed .
The water heating phase starts in the thermoblock,
whose temperature shall reach the pre-set value.
PLEASE WAIT...
TEMPERATURE
Now the vending machine is ready to dispense on
a free basis and the display will alternatively show
some stand-by messages.
LAVAZZA
TAKE A RELAX
MOMENT
16
PREPARING THE MACHINE
SANITISING MIXERS AND FOOD CIR-
CUITS FOR THE FIRST TIME
As soon as you install the machine, carefully dis-
infect the mixers, the tubes intended to dispense
instant drinks and the internal tank in order to guar-
antee the hygiene of dispensed products.
It is absolutely forbidden to use water jets for
cleaning .
Open the front door on the back of the dispenser
door, to access the display board.
Press the programming button:
1= PROG
3= CLEANING
Press "3" to enable the wash cycles of the water cir-
cuit.
CLEANING
BUTTON 1
Press key "1" to dispense water through the in-
stant bowl. Repeat the operation some times to
rinse completely; during the wash cycle the display
shows:
CLEANING 1
IN PROGRESS
Ca . 50 cc . water will be dispensed for each wash
cycles .
At the end of the wash cycle, the display shows:
CLEANING
BUTTON 1
2= DATA