Determine The Suction Fan Time - LAVAZZA Magystra LB 2600 INT Installation And Maintenance Manual

Enabling this function, only during a selection deliv-
ery the selection can be interrupted by pressing any
selection key.
BUTTON STOP
1=ENABLED
After dispensing, the piston will wait for the time set
up here (in seconds) before starting its stroke up.
PAUSE TIME AFTER
DISPENSING
It sets up the time (in seconds) the coffee unit pis-
ton requires to move from the dispensing position
to the decompressing position.
ASCENT TIME
It sets the break time (in seconds) in the decom-
pressing position, after which it will reach the wait-
ing position. If the value of the three variables is
zero, the action is not carried out.
PAUSE TIME AFTER
THE ASCENT
It is used to ensure hydraulic circuit filling at first
power-on after disinstallation. If the value is zero, at
next power-on, the machine will perform the cycle
as described in paragraph "FIRST POWER-ON".
FIRST INSTALLATION
0=FIRST
About 50 cc of hot water will be dispensed .
PROGRAMMING
Deinstallation it's used to empty water circuits auto-
matically. To start the sequence, press button "3".
0
About 50 cc of hot water will be dispensed .
Remove the water tank and press "1", as it is shown
on the display. The water circuit will be totally emp-
tied during uninstallation.
0.0*
REMOVE WATER
TANK PRESS SEL. "1"
0.0*
Wait for the phase to come to an end when the dis-
play shows the "end of uninstallation" message.
It loads the "1A" standard configuration pre-set by
0.0*
default.

DETERMINE THE SUCTION FAN TIME

1
To remove the residual powder of instant products
from inside the machine, it is recommended to use
the value in minutes you have already programmed
(one). If you should use particularly volatile prod-
ucts, increase the time to five (and more) minutes.
DEINSTALLATION
3=START
DEINSTALLATION
IN PROGRESS
END
DEINSTALLATION
DATI STD. V 1A
3=START
EN
23