Electric Connection - LAVAZZA Magystra LB 2600 INT Installation And Maintenance Manual

EN

ELECTRIC CONNECTION

It is absolutely necessary to use a main switch in
compliance with the installation rules in force,
placed in an accessible position . It shall be fea-
tured in such a way that it can support the maxi-
mum load required as well as ensure complete
disconnection from the mains on the conditions
of overvoltage category III and, therefore, the
protection of circuits against earth faults, over-
loads and short-circuits .
The switch, the power socket and the correspond-
ing plug shall be located in an accessible position.
The electrical safety of the machine is only en-
sured when the machine is correctly and efficient-
ly grounded according to the safety standards in
force.
It is necessary to check this fundamental safety
requirement and, in case of doubt, to require pro-
fessionally qualified personnel to check the instal-
lation carefully .
It is recommended to install a differential current de-
vice operating below 30 mA, detaching the machine
from the mains and promptly tripping in case of im-
proper electric input in order to considerably reduce
the risks arising out of any short-circuit
The power cable is flexible type and is separated
from the machine. If necessary, the connection ca-
ble shall be replaced by qualified personnel by us-
ing only cables of the H05 RN - F or HO5 V V-F or
H07 RN-F type, 3x1-1.5 mm
It is forbidden to use adapters, multiple sockets
and/or extensions .
The manufacturer disclaims all responsibility for
any damage caused by the non-observance of
the precautions mentioned above .
10
INSTALLATION
.
in cross-section.
2
Plug the power cord into the socket at the back of
the machine.
Plug the cord into the mains socket.
Press the main switch and put it in position [ON].
The display will show the machine is turned on.