Electric Connection; Handling And Storage; Handling; Storage - LAVAZZA LB GUZZINI Maintenance Manual For Technical Assistance

3.2. Electric connection

The machine must be connected to a 240V elec-
tric outlet.
Referring to the rules in force in the country where
the machine is used, the power cord, must be pre-
disposed with an all-pole switch (with a contact
separation of 3 mm. minimum).
The all-pole switch should be suitable with the con-
sumption of the machine and able to intercept all
the polarity of the voltage.
Check that the electric cables of the system are
proportioned with the absorption of the machine.

4. HANDLING AND STORAGE

4.1. Handling

During handling and transport, the machine must
remain in a vertical position according to the
directions on the packaging. Carry out lifting and posi-
tioning with care. Do not shake the machine.

4.2. Storage

The machine should be stored according to the follo-
wing conditions:
- minimum temperature: above 4°C;
- maximum temperature: below 40°C;
- maximum humidity: below 95%.
The machine is packaged in cardboard.
Given the total weight of the package, it is prohibi-
ted to stack more than three machines. The machi-
ne should be stored, in its original packaging, in a
dry and clean place.
4
Maintenance manual for technical assistance - LB GUZZINI

5. DISMANTLING

Attention
Disposal of machine components after dismantling,
should be carried out with respect for the environ-
ment, avoiding pollution of the soil, water and air.
Any operation should comply with local legislation
Warning
in force.
To make the machine unusable, remove the power
cord.
Deliver the unserviceable machine to an appropriate
collection centre.

5.1. Instructions for end of life treatment

This product conforms to the EC Directive 2002/96/EC.
The symbol applied on the equipment or on the
packaging indicates that, at the end of its life,
the machine should not be treated as a generic
household waste but should be delivered to an
authorised centre for collection of WEEE set up by the
Public Administration. Otherwise it could be delivered to
the retailer when a new machine is purchased.
The user is responsible for sending the equipment at its
end of life to the appropriate collection centres, there is
a penalty if current legislation on waste is not followed.
Collecting the components of the machine in properly
separated fractions will enable recycling, treatment and
environmentally friendly disposal and contribute to avoi-
ding possible adverse effects on the environment and
on the human health.
For more information regarding available collection
systems, contact the local waste disposal service, or the
retailer where the equipment has been bought. The
manufacturer and/or the importer are responsible for the
recycling, treatment and disposal in an environmentally
safe manner either individually or by joining a collective
scheme.
Disposal of the machine or its components, should
be performed in an environmentally sound way and
Warning
according to the local standards in force.
Manual code 10083088 / Rel. 0.00 / January 2008
Environment
Environment