Maintenance - RaycoWylie i3500 Instruction Manual

6.4

Maintenance

Replacement
RaycoWylie as original parts, unless approved and
authorized as an equivalent by a Service technician
of RaycoWylie.
Preventive maintenance
• Your i3500 system has been designed to operate over long periods of time
with minimum maintenance. However, continuous satisfactory operation
depends upon system's care and cleaning.
Important: Do not use pressure steam on the i3500 display box,
junction boxes, angle sensor, load cells or on any connectors.
This could result in moisture in the connectors and can cause
eventual sensor failure.
• To clean the display's surface, use mild soap or mild window cleaners and
a clean soft cloth.
Important: If condensation appears in the screen of the
display unit, open the cover in a dry place and let it air dry
for a day.
• Replace all cables showing cut or damage or corroded connector contacts.
• Replace reeling drum's brushes if they show excessive wear.
• Replace ATB switch if the plunger shows excessive corrosion.
• To keep the waterproofness of the i3500's display the back cover must be
tighten following an X pattern.
• Your i3500 system requires no additional lubrication.
Telescopic Cranes Pressure Sensing
parts must be
65
obtained from
i3500 Maintenance
Instruction Manual