RaycoWylie i3500 Instruction Manual page 64

5.7.1 Internal Peripherals (cont'd)
Error message
External board
(Logger)
Low battery on
data logger
No duty
No Parameter
No 2nd duty found
Telescopic Cranes Pressure Sensing
Execution process
The Logger option must be
activated. Upon startup, the
system verifies that logger
card is present.
The System detected that the
Lithium battery is low. This
may cause clock to stop or
lose precision.
The present crane configu-
ration is not valid.
The Crane dimensions must
be entered in the system.
The Load value will be null
or wrong.
The Comparison angle/
radius" option must be
activated. Thus a jib capacity
is evaluated by its angle
(offset) against the jib's chart,
in comparison to the same
jib's capacity evaluated by
its radius against the Main
boom chart. The smallest
will be selected.
58
i3500 Troubleshooting
Cause of error
1) The Logger card is not
installed,
2) There is a problem
with one of the two flash
memories.
1) The Logger card's plastic
cap must be replaced. It
contains the battery.
(See illustration below for
replacement).
1) Verify if the load chart
corresponds to the crane
to be calibrated.
2) Does load chart depend
on rotation?
3) Does load chart depend
on DIN inputs?
1) CL3, CL4 and CL7 values
should Not be at zero.
1) The Load chart must be
programmed for this kind
of application. "One
touch" field is used in the
load chart for this option.
Instruction Manual