4- Variable Limit Height - RaycoWylie i3500 Instruction Manual

4.6.4
Telescopic Cranes Pressure Sensing
Variable Limit Height
1) Access the Range limiting mode (see page 44).
2) Use the Parts/Scroll down (3) button to highlight the
''Variab limit height'' option.
3) Press Select (4) button to confirm your choice.
4) Rotate the crane to the first limit position (first wall).
Press Select (4) button to confirm that this will be the posi-
tion of the first wall.
5) Rotate the crane toward the second limit position (second
wall) with the boom tip always at the maximum height per-
mitted by the surrounding environment. Press Select (4)
button to confirm the position of the second wall. As you
release Select (4) button, an 8-second countdown will allow
you to return between the two walls and boom down below
the height limit before your programmed variable height
limit becomes active.
6) T
o go back to Normal mode,
key switch'' to the ''Normal run'' position or ''Tracks
Stopped'' option (if available).
turn the
''Range limiting
47
i3500 Operation
Instruction Manual