5- Variable Limit Radius - RaycoWylie i3500 Instruction Manual

4.6.5 Variable Limit Radius
1) Access the Range limiting mode (see page 44).
2) Use the Parts/Scroll down (3) button to highlight the
3) Press Select (4) button to confirm your choice.
4) Rotate the crane to the first limit position (first wall).
5) Rotate the crane toward the second limit position (second
6) T
Telescopic Cranes Pressure Sensing
''Variab limit radius'' option.
Press Select (4) button to confirm that this will be the posi-
tion of the first wall.
wall) with the boom tip always at the maximum radius per-
mitted by the surrounding environment.
Press Select (4) button to confirm the position of the second
wall. As you release Select (4) button, an 8 second countdown
will allow you to return between the two walls and boom up
within the allowed radius limit before your programmed variable
radius limit becomes active.
o go back to Normal mode,
key switch'' to the ''Normal run'' position or ''Tracks
Stopped'' option (if available).
turn the
''Range limiting
48
i3500 Troubleshooting
Instruction Manual