Diagnostic Menu - RaycoWylie i3500 Instruction Manual

5.0 Diagnostic & Troubleshooting
Warning! Troubleshooting shall be performed by a qualified
technician or by an operator with assistance of a RaycoWylie
Service technician.
This section provides technical troubleshooting support. It will address most
frequently asked questions that repair personnel may have when installing,
repairing or performing maintenance on the i3500 system.
5.1 Diagnostic Menu
or
The information provided by the diagnostic menu has been divided into sev-
eral menu pages. Each page applies to one type of sensor at the time or one
particular type of information. The different menu pages available are: angle/
length, load, relay, general info (for a specific type of calibration e.g. telescopic
multi-point), rotation as well as the addresses of all sensors detected by the
i3500 system. Regardless of system configuration, a minimum of three menu
pages are always provided: angle/length, general info and detected addresses.
Additional pages are optional and are only shown if one or more sensors are
enabled (refer to the option enable/disable I/O in the calibration menu).
The use of the Scroll Up/Down arrow
user to scroll in the menu. When pressing simultaneously on the Scroll Up or
Down arrow button and the
the next. Pressing the
original software version of the highlighted sensor.
• This feature is not available for all sensors.
• Pressing the Escape
exits the diagnostic mode.
Telescopic Cranes Pressure Sensing
A diagnostic menu provides information on the sys-
tems status and the state of all connected sensors.
To access the diagnostic menu:
Press Mode (1) button
Use the Hoist/Scroll up (2) or Parts/Scroll down
(3) button to highlight your the diagnostic option.
Press Select (4) button to enter the diagnostic menu.
key, the display will move from one page to
key will show calibration details and also the
button takes you to the previous menu or
50
i3500 Troubleshooting
buttons will allow the
Instruction Manual