MOUNTING INSTrUcTIONS fOr cONTrOL cAbINeT INSTALLATION
3.3 Mounting instructions for control cabinet installation
For mounting the drive controllers, the following fastening materials with the correspond-
ing quality were tested by KEB.
required material
Screw assembly ISO 7045 - M6 - 8.8
Table 8:
NOTICE
32
Mounting instructions for control cabinet installation
Use of other fastening material
► The alternatively selected fastening material must comply with the
above-mentioned material characteristics (quality) and tightening
torques !
The use of other fixing materials is beyond KEB's control and is there-
fore the sole responsibility of the customer.
Tightening torque
3.2 Nm
29 lb inch