Synchronization - NovaStar VX1000 User Manual

Input sources A and B form a hot backup group. The current input source of the layer is input source A.
−
Input A: No signal. Input B: Signal
The layer input source is switched to input B automatically. When input A resumes and input B still has
a signal, the layer input source will not be changed.
−
Input A: No signal. Input B: Signal
The layer input source is switched to input B automatically. When input A resumes, but input B does not
have a signal, the layer input source will be changed to input A.
−
Input A: No signal. Input B: No signal
The layer input source will not be changed.
−
Input A: Signal. Input B: No signal
If you manually switch the layer input source to input B, the source will automatically switch to input A.

Mosaic backup source descriptions:
−
MOSAIC (H) indicates this mosaic source comprises HDMI sources, and MOSAIC (D) means this
mosaic source is composed of DVI sources.
−
After the backup settings for a mosaic source take effect, the mosaic layout and size of the primary
mosaic source are also applicable to the backup mosaic source. When any input source in the primary
mosaic source is lost, the corresponding source in the backup one will be used. For example, if HDMI 1
is lost, DVI 1 will be used; if HDMI 2 is lost, DVI 2 will be used; if HDMI 1 and HDMI 2 are both lost, the
backup mosaic source MOSAIC (D) will be used.
−
When the backup settings for a mosaic source do not take effect, no backup source will be used if any
source is lost.

5.8.3 Synchronization

This function allows you to select a synchronization signal to synchronize all the cascaded device units or
synchronize the primary and backup devices to display the output images of all the units in sync.
Step 1 On the main menu screen, go to Advanced Settings > Synchronization to enter the synchronization settings
screen.
Figure 5-32 Synchronization
Step 2 Rotate the knob to select Status and press the knob to confirm. Rotate the knob again to select On and press
the knob to confirm.
Step 3 Rotate the knob to select Source and press the knob to confirm. Then rotate the knob again to select the
desired sync source.
Note:
If two or more VX1000 units load an LED screen, the sync sources used by each device must be the same.
www.novastar.tech
VX1000 All-in-One Controller User Manual
31