Preset Settings - NovaStar VX1000 User Manual

Figure 5-20 Mosaic
Step 2 Select the desired mosaic layout.
Two layout templates are supported:
Step 3 Set Width and Height for each mosaic area.
Both the width and height values range from 64 to 2048 pixels.

If the input source width or height is less than the width or height value you set, the blank area will be filled
with solid black.

If the input source width or height is larger than the width or height value you set, the input source image
will be cropped. The cropping takes the top left corner of the input source image as the reference point and
then crops the image according to the set width and height values.
Step 4 Rotate the knob to select the total resolution line, and press the knob to confirm. Then rotate the knob again to
set the mosaic source.
Notes:

When you change the mosaic layout and size, the total resolution changes accordingly in real-time. The
total resolution indicates the size of the mosaic source.

Only the sources of the same type can be mosaicked.

You can only set the mosaic source in the left/top rectangle, while the source on the right/bottom will be
set accordingly.
Step 5 Rotate the knob to select Apply to make the settings take effect; otherwise, select Reset to reset the settings
to defaults.
Note:
After a PIP layer is opened, the mosaic source cannot be used. Only the main layer can use the mosaic
source.

Preset Settings

A preset is a set of parameters that save the layer and layer-related information. The VX1000 supports ten
user-defined presets. After a preset is saved, you can load the preset simply by its name. The preset
operations include Save, Load, Clear and Copy To.
On the home screen, press the knob to enter the main menu screen. Rotate the knob to select Preset
Settings and press the knob to enter the preset settings screen.
www.novastar.tech
VX1000 All-in-One Controller User Manual
and .
23