Rename Presets; Image Mosaic - NovaStar VX1000 User Manual

Step 3 Rotate the knob to select Copy To and press the knob to go back to the preset settings screen.
Step 4 Rotate the knob to select the target preset and press the knob to confirm.
After the copying, the status of the target preset changes to Saved.

5.5.5 Rename Presets

The VX1000 allows you to rename the presets in V-Can. After a successful renaming, the new name will be
shown on the device screen.
Note:
For the exact method and steps of how to rename a preset in V-Can, please refer to V-Can User Manual.

Image Mosaic

When the pixel count of an LED screen is larger than the loading capacity of a single VX1000 unit, the image
mosaic function is required. You can use multiple device units together to load the LED screen.
Prerequisites
Before using the image mosaic function, ensure that you turn on the synchronization function on each device
and all the devices use the same input source as the sync source.
Figure 5-22 Connection method for image mosaic
Notes
After the image mosaic function is turned on, the full screen scaling and pixel to pixel display of the layer are
unavailable.
Operating Procedure
Step 1 On the main menu screen, rotate the knob to select Image Mosaic and press the knob to enter the image
mosaic settings screen.
Step 2 Rotate the knob to select Status and press the knob to confirm. Rotate the knob again to select On and press
the knob to confirm.
www.novastar.tech
VX1000 All-in-One Controller User Manual
25