Volume; Input Hdcp; Low Latency - NovaStar VX1000 User Manual

Figure 5-37 Audio output

Off: Turn off the audio.

Main Layer/PIP 1/PIP 2: Play the audio that comes with the main layer, PIP 1 or PIP 2.
Step 3 Press the knob to complete the selection.

5.8.5.2 Volume

Adjust the audio volume.
The value ranges from 0 (silent) to 100 (loudest) and defaults to 50.
On the audio settings screen, rotate the knob to select Volume and press the knob to confirm. Then rotate the
knob again to adjust the audio volume and press the knob to confirm.

5.8.6 Input HDCP

High-bandwidth Digital Content Protection (HDCP) is a form of digital copy protection to prevent copying of
digital audio and video content as it travels across connections. When the accessed input source is an HDCP-
encrypted one, you need to turn on this function to enable the device to transmit and process the source.
On the main menu screen, go to Advanced Settings > Input HDCP and press the knob to enable the
settings. Then rotate the knob again to select On or Off and press the knob to confirm the selection.

On: Turn on the transmission and processing functions for the input source.

Off: Turn off the transmission and processing functions for the input source.

5.8.7 Low Latency

When the input source travels from where it comes to the processing device, sending device and then the
receiving card, latency exists inevitably. Turning on this function can effectively help to reduce the latency from
the input to output.
The VX1000 can reduce the delay from the input to receiving card to as low as 1 frame when the low latency
and synchronization functions are both turned on and the data runs vertically on the screen.
On the main menu screen, go to Advanced Settings > Low Latency and press the knob to confirm. Then
rotate the knob again to select On or Off and press the knob to confirm the selection.
5.8.8 3D
The VX1000 can work with the EMT200 3D emitter and 3D glasses to provide you with a 3D visual
experience.
Notes:

Turning on the 3D mode will halve the device output capacity.

To enable the pixel-to-pixel display of a 3D video source, set the layer width to half of the resolution width
of the 3D source if it is side-by-side, or set the layer height to half of the resolution height of the 3D
source if it is top-and-bottom.
www.novastar.tech
VX1000 All-in-One Controller User Manual
34