General Description; Screen Operation - JLG TOUCAN DUO Service Manual

VII-1

7.1 General Description

The Eco Smart Display is connected to the platform
onboard system by the CAN-BUS link. It gives access
to the different menus and parameters of the master
and slave controllers.
It is fitted with 5 RED indicators which keep you
informed at all times, of the system condition for the
drive movements.
To browse into the different menus, use the down and
up arrows. The left and right arrows are used to change
the parameters value. The central button enables the
changes.
1- The indicator lights when the battery voltage
measured bu the controllers is less than or
equal to 40% of the nominal battery voltage.
2- The indicator lights when a default has been
detected by the controllers.
3- The indicator lights if one of the controllers faults
because of a high temperature.
4- The indicator lights as soon as the operator
push on the movement enable trigger.
5- The indicator lights if the motor brakes are not
actuated (machine braked).
NOTE
At every machine power up, a general test is
accomplished during which all indicators
light successively.
Models
Updated 06-2015
ECO SMART DISPLAY
TOUCAN Duo

7.2 Screen Operation

1- The battery's state of charge indication is
displayed on the left side of the screen. It
consists of 10 horizontal bars, representing
each, 10% of the battery charge.
As the battery becomes discharged, the bars
turn off progressively one after the other.
2- The number displayed in the top right side
shows the performance mode which is being
used by the controllers. This performance level
is factory preset and cannot be modified.
3- The "turtle" symbol appears when the mast has
left its lowered position; the translation speed
is then reduced.
4- The number displayed on the bottom right side
shows the Hours Worked accomplished with
the drive movement.
5- The accelerator level indication is displayed at
the top of the screen. It consists of 8 vertical
bars which displays as the speed increases.
6- The number displayed at the center of the
screen corresponds to the approach value of
the machine speed. This value is given for
information only and does not necessary
correspond to the actual machine speed.
7- The bar displayed indicates the direction of the
steering wheels. Only one of the nine bars is
lit at a time.
8- The arrow indicates the driving machine
direction. The arrow point is up when the
machine is in forward drive; the arrow point is
down when the machine is in reverse.
If the machine is not running a dot is displayed
instead of the arrow.
VII-1
87