Chassis; Removal - Installation Of The Driving Wheels (Rear Wheels); Removal - Installation Of The Steering Wheels (Front Wheels) - JLG TOUCAN DUO Service Manual

VI-4 REMOVAL - INSTALLATION PROCEDURES

6.4 Chassis

6.4.1 Removal - Installation of the driving
wheels (rear wheels)
Removal
1- Lower the platform
2- Chock the front wheels lengthways.
3- Lift the chassis of the platform and place a block
under the rear of the chassis.
4- Remove both bolts securing the wheels as
indicated on the drawing below:
Installation
1- Coat the bolts with Loctite 222 over the whole
thread.
2- Install the wheels on the motor reducer shaft
and secure them with both bolts without
forgetting the washer.
3- Remove the blocks from the machine.
! CAUTION
Clean and grease the motor reducer shaft
before installing the wheels.
! CAUTION
When installing the rear wheels, torque the
bolts to 21 N.m (torque with a torque wrench).
Models
Updated 06-2015
A t t a c h m e n t
bolt
TOUCAN Duo
6.4.2 Removal - Installation of the steering
wheels (front wheels)
1- Lower the platform.
2- Chock the rear wheels lengthways.
3- Loosen the 4 nuts without removing them.
4- Lift the front of the chassis and place a block
under the chassis.
5- Remove the 4 nuts and remove the wheel.
CAUTION
!
When installing the front wheels, torque the
attachment nuts to 119 N.m (torque with
torque wrench).
Wheel nuts
VI-4
75