Table of Contents
Advertisement
ATM Traffic Parameter Defaults Screen
ATM Traffic Parameter Defaults
Main Menu\ATM Circuit
Management\ATM Traffic Parameter Defaults
The ATM Traffic Parameter Defaults screen (see
the ATM circuits. Traffic parameters represent priorities given to ATM cell transmissions.
Once traffic parameters are set from this screen, all PVC/PVPs provisioned from that point
forward will use these parameter defaults.
TID: TA1248
Unacknowledged Alarms: None
Traffic Type
UBR
CBR
VBR-rt
VBR-nrt
Traffic Type
UBR
CBR
VBR-rt
VBR-nrt
Note: This screen allows modification of the DEFAULT traffic parameter settings,
which can be overridden on a per PVC/PVP basis in the PVC/PVP Management menu.
Figure 5-20. ATM Traffic Parameter Defaults Screen
The ATM Traffic Parameters Defaults screen Traffic Types are shown in
Table 5-18. ATM Parameters Defaults Screen Traffic Types
Traffic Type
PCR
SCR
MCR
MBS
61179641AL1-5C
Total Access 1248
ATM Traffic Parameter Defaults
Endpoint 2 -> Endpoint 1
PCR(0+1)
SCR(0+1)
Best Effort
N/A
0
N/A
0
0
0
0
Pkt Discard
Enabled
Enabled
Enabled
Enabled
Definition
The Peak Cell Rate designates an upper limit that the traffic
information rate cannot exceed.
The Sustainable Cell Rate specifies the average traffic rate that
is transmitted and received.
The Minimum Cell Rate designates a minimum limit that the
traffic information rate cannot fall below.
The Maximum Burst Size specifies the maximum number of
cells per second (CPS) that can be transmitted at the PCR.
Figure
5-20) displays the system defaults for
MCR(0+1)
MBS(0+1)
N/A
N/A
N/A
N/A
N/A
0
N/A
0
Menu Descriptions
Table
5-18.
5-35
Advertisement
Table of Contents
