Table 5-31. Mode Selection And Current Ip Settings Menu Items - ADTRAN Quad T1 IMA Installation And Maintenance Practice

Table 5-31. Mode Selection and Current IP Settings Menu Items

Option Description
1 IP Feed
2 Mode
3 Configure IP
The Media Access Control (MAC) address, which is set at the
factory, is required to configure the DHCP server.
61179641AL1-5C
Function
This option provides 3 choices for the selection of IP
Feed type:
• RFC1483 Routed Encapsulation
• IP over Ethernet
• RFC1483 Bridged Encapsulation
The VPI and VCI of the ATM circuit must be assigned by
configuring the IP settings.
This option is used to select either Static or Dynamic.
• In Static Mode, the IP address, Subnet mask, and
Default Gateway are configured manually for
inband management of the device.
• In Dynamic Mode, the Total Access 1248 acts as a
Dynamic Host Configuration Protocol (DHCP) client
and a DHCP server is required upstream from the
device to configure the IP settings.
When a DHCP server is properly configured, the
Total Access 1248 system obtains the IP address,
Subnet mask, and Default Gateway from the server
and applies these settings to the device.
Depending on the setting of the IP Feed and Mode
options, the Configure IP option displays one of the
following menus:
• "Static IP Settings - for IP over ATM Menu"
page 5-54
• "Dynamic IP Settings - for IP over ATM Menu"
page 5-57
• "Static IP Settings - for IP over Ethernet Menu"
page 5-60.
• "Dynamic IP Settings - for IP over Ethernet Menu"
on page 5-63.
NOTE
Menu Descriptions
on
on
on
5-53