Table of Contents
Advertisement
Total Access 1248 Quad T1 IMA 48-Port DSLAM with Modem Installation and Maintenance Practice
The System Management menu TFTP IP address option must be
configured to use TFTP.
Y-Modem Menu
Y-Modem
Main Menu\System Management\Code Download
The Y-Modem menu (see
Total Access 1248 through the craft port.
To expedite the download time, change the baud rate to 38400 bps
prior to downloading code. For more information, refer to
Baud Rate Menu"
TID: TA1248
Unacknowledged Alarms: None
To download code via the Y-Modem menu, perform the following steps:
1. Access the system with System Administrator privileges using a terminal application that
allows file transfers, such as HyperTerminal.
2. From the Y-Modem menu, select
The Y-Modem receive utility begins.
3. If using HyperTerminal, select
5-78
NOTE
Method\Y-Modem\
Figure
5-49) is used to download code stored from a computer to the
NOTE
on page 5-68.
WARNING! THIS IS SERVICE AFFECTING!
Y-Modem is the file transfer protocol.
This function cannot be initiated via a telnet
connection (use TFTP instead).
1. Download Network Module Code
2. Exit
Selection :
'?' - System Help Screen
Figure 5-49. Y-Modem Menu
Download Network Module Code
from the menu, and select
Transfer
Total Access 1248
, and press
"Current
MM/DD/YY
HH:MM
.
E
NTER
.
Send File
61179641AL1-5C
Advertisement
Table of Contents
