Ima Link Failure Monitoring Status Screen; Figure 5-88. Ima Link Failure Monitoring Status Screen; Table 5-90. Ima Link Failure Monitoring Status Screen States And Failure Conditions - ADTRAN Quad T1 IMA Installation And Maintenance Practice

IMA Link Failure Monitoring Status Screen

IMA Link Failure Monitoring Status
Main Menu\Network Port\IMA Main Menu\Status/Failure
The IMA Link Failure Monitoring Status screen (see
the facilities.
TID: TA1248
Unacknowledged Alarms: None
NE Tx State:
NE Rx State:
FE Tx State:
FE Rx State:
NE Rx Failure:
FE Rx Failure:
DiffDelay(ms):
Rx LIF Defect:
Rx LODS Defect:
Rx Link ID:
Timing Source
Last Timing Source Change : MM/DD/YY HH:MM:SS

Figure 5-88. IMA Link Failure Monitoring Status Screen

The IMA Link Failure Monitoring Status screen states and failure conditions are shown in
Table 5-90.
Table 5-90. IMA Link Failure Monitoring Status Screen
State Definition
Near End Tx States
NotInGr Not In Group, Unassigned
Deleted Not In Group, Deleted
Fault Unusable, Fault
No Reas Unusable
61179641AL1-5C
Monitoring\IMA Link Failure Monitoring Status\
Total Access 1248
IMA Link Failure Monitoring Status
Fac1 Fac2 Fac3
Active Active Active
Active Active Active
Active Active Active
Active Active Active
NoFault NoFault NoFault NoFault
NoFault NoFault NoFault NoFault
>MaxDel >MaxDel >MaxDel >MaxDel
0 1 2
: Port 1
'?' - System Help Screen
States and Failure Conditions
Failure Condition
This condition indicates that no information about the
link exists.
This condition indicates the link has been removed from
the group.
This transitional state ensures that the other end is still
not receiving ATM layer cells before it moves to the
Unassigned state.
This condition indicates that a fault has been detected
either on the link or in the link protocol.
This condition indicates that a reason was not given.
Figure 5-88) displays the states for all of
Fac4
Active
Active
Active
Active
3
Menu Descriptions
MM/DD/YY HH:MM
5-127