Installing Oracle Solaris - Fujitsu SPARC M12-1 Installation Manual

6.13

Installing Oracle Solaris

Oracle Solaris is preinstalled on the SPARC M12-1. By using this preinstalled OS, you
can streamline system configuration. According to the purpose, either use the
preinstalled Oracle Solaris as is or reinstall it.
When using the preinstalled Oracle Solaris
Execute the showpparparam command to check the set value of the
1.
OpenBoot PROM environment variable auto-boot?.
The set value is "false" in the following example.
XSCF> showpparparam -p 0 -c auto-boot
auto-boot? :false
2. If the value is "false," execute the setpparparam command to change the
setting of auto-boot? to "true."
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? true"
OpenBoot PROM variable bootscript will be changed.
Continue? [y|n] : y
Execute the poweron command to start the physical partition.
3.
XSCF> poweron -a
PPAR-IDs to power on:00
Continue? [y|n]: y
00:Powering on
*Note*
This command only issues the instruction to power-on.
The result of the instruction can be checked by the
"showpparprogress".
Execute the console command to switch to the console.
4.
A message appears when the console is switched.
XSCF> console -p 0
Console contents may be logged.
Connect to PPAR-ID 0?[y|n] : y
POST Sequence Complete.
5. An OS setting screen appears. Proceed interactively with the settings.
Chapter 6 Making the Initial System Settings 107