Chapter 4
Connecting Cables
This chapter describes the procedure for connecting the power cords, serial cable,
and network cables to the SPARC M12-1 and the PCI expansion unit. All ports for the
connections are on the rear of the chassis. For a description of each port, see
Checking External Interface Port
Connecting Cables to the SPARC M12-1
■
Connecting Cables to the PCI Expansion Unit
■
4.1
Connecting Cables to the SPARC
M12-1
This section describes the procedure for connecting the serial cable, network cables,
and power cords to the SPARC M12-1.
1.
Figure 4-1 Serial Port Location on the XSCF Unit
2.
Connect the serial cable supplied with the SPARC M12-1 from the serial port
of the XSCF unit (A in
A
Connect a LAN cable of Category 6 or higher from a 10 GbE port (A in
4-2) to the network switch or hub.
The 10 GbE ports are used for the user network. Connect every other server, PC,
UPS, etc. that is necessary for business via the network switch or hub.
Specifications."
Figure
4-1) to the system management terminal.
"2.10
Figure
67