Fujitsu SPARC M12-1 Installation Manual page 109

configuration policy (specifying the degradation range for an error detected by an
initial diagnosis of the hardware).
Use the showpcl command to check a PPAR configuration list (PCL), and use the
setpcl command to set a PCL. For an explanation of the setpcl command options, see
the setpcl command man page or the Fujitsu SPARC M12 and Fujitsu M10/SPARC
M10 XSCF Reference Manual.
In the case of the SPARC M12-1, a single SPARC M12-1 is treated as one physical
partition (PPAR). Firmware treats the SPARC M12-1 in this circumstance as a single
physical system board (PSB). The PPAR is defined by assigning the number of the
logical system board (LSB) corresponding to the single PSB.
Execute the showpcl command to check a PPAR configuration list.
1.
XSCF> showpcl -a
PPAR-ID LSB
00
00
2. Execute the setpcl command to set the configuration policy for all physical
partitions as a whole.
XSCF> setpcl -p ppar_id -s policy=value
For value, specify fru, psb, or system as the degradation unit.
Between psb and system, whichever is specified, the range of degradation is the
same. The default setting is fru.
The following example sets the configuration policy to "All physical partitions"
for physical partition 0.
XSCF> setpcl -p 0 -s policy=system
Execute the showpcl command to check the set PPAR configuration list.
3.
XSCF> showpcl -v -a
PPAR-ID LSB PSB
00
00 00-0
01 -
02 -
03 -
04 -
05 -
PSB Status
Powered Off
00-0
Status No-Mem
Powered Off
False
Chapter 6 Making the Initial System Settings
No-IO Cfg-policy
System
False
99