Fujitsu SPARC M12-1 Installation Manual page 138

Table C-1 SPARC M12-1 Workflow (From Installation to Initial Diagnosis) (continued)
Work Description
8 If there are optional components, mount
them in the SPARC M12-1 and PCI
expansion unit.
(For details, see the service manual.)
9 Connect serial cables, LAN cables, and
power cords to the SPARC M12-1.
10 Connect the link cable and management
cable to the PCI expansion unit and the
SPARC M12-1.
Attach the core to the power cord, and
connect the power cord to the PCI
expansion unit.
11 Connect the system management
terminal to the SPARC M12-1.
12 Turn on the input power, and check the
status with the LED display on the XSCF
unit.
13 Log in to the XSCF.
14 Check the XCP version.
15 Set the altitude.
16 Set the time.
17 Perform the initial diagnosis test on the
hardware. (*1)
18 Confirm that that each component is
normally recognized, and no errors occur.
*1 The probe-scsi-all command and the show-devs command are displayed with command options for the diagnosis test.
Confirm that the capacity and number of installed disks and the installation locations and device names of PCI Express cards are correct.
128 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
Check Checked Installation Guide Reference
By
[ ] "3.5.1 Mounting Optional Components in the
SPARC
"3.5.2 Mounting Optional Components in the
PCI Expansion
In the Fujitsu SPARC M12-1 Service Manual:
"Chapter 8 Maintaining the PCI Express Cards"
"Chapter 9 Maintaining Internal Storage"
"Chapter 16 Maintaining the Motherboard
Unit/Memory"
[ ] "4.1 Connecting Cables to the SPARC
[ ] "4.2 Connecting Cables to the PCI Expansion
Unit"
[ ] "5.1 Connecting the System Management
Terminal to the
[ ] "5.2 Turning On the Input Power and Starting
the XSCF"
[ ] "5.3 Logging In to the
[ ] "5.4 Checking the XCP
[ ] "5.5 Checking the Altitude
[ ] "5.6 Setting the
[ ] "5.7 Performing a Diagnosis
[ ] "5.8 Checking the Component
M12-1"
Unit"
Chassis"
XSCF"
Version"
Setting"
Time"
Test"
Status"
M12-1"