Performing A Diagnosis Test - Fujitsu SPARC M12-1 Installation Manual

Execute the showtimezone command.
7.
Confirm that it shows the set time zone.
XSCF> showtimezone -c tz
Asia/Tokyo
Execute the showdate command.
8.
Confirm that it shows the set time.
XSCF> showdate
Fri Oct 20 17:05:00 JST 2017
5.7

Performing a Diagnosis Test

This section describes the procedure for performing an initial diagnosis on the
hardware before starting the system.
Note - The SPARC M12-1 is powered on and off during the diagnosis test.
For power-on during the diagnosis test, CPU Activation keys do not need to have been
registered.
1. Execute the testsb command.
The testsb command performs an initial diagnosis on the hardware.
The command powers on and off the SPARC M12-1 during the diagnosis. By
specifying options, you can check whether HDD/SSD/PCIe cards are mounted.
The following example performs an initial diagnosis and connection I/O check of
the SPARC M12-1.
<Description of options specified>
-v: Additionally displays detailed messages of the initial diagnosis
-p: Executes the "probe-scsi-all" command of OpenBoot PROM and displays the
-s: Executes the "show-devs" command of OpenBoot PROM and displays the
-a: Diagnoses all the mounted PSBs
-y: Automatically responds with "y" to a query
results while a diagnosis is being processed
If the PCI expansion unit is connected, the results from the following XSCF
command are displayed: ioxadm -v list.
results while a diagnosis is being processed
If the PCI expansion unit is connected, the results from the following XSCF
command are displayed: ioxadm -v list.
Chapter 5 Performing an Initial System Diagnosis 81