Checking Environmental Conditions - Fujitsu SPARC M12-1 Installation Manual

Figure 2-5 Example of Service Areas for the PCI Expansion Unit (Top View)
(*1)
*1 To mount a chassis in the rack, an area with a depth of 1,200 mm (47.2 in.) is required in front of the rack, and
areas with a width of 600 mm (23.6 in.) are required on both the left and right sides of the front service area. If
there is a possibility that a chassis will be added later, secure an area with a depth of 1,200 mm (47.2 in.) in front
of the rack and areas with a width of 600 mm (23.6 in.) on both the left and right sides of the front service area.
2.5

Checking Environmental Conditions

This section describes the environmental conditions for the SPARC M12 systems. The
server can be installed at locations that meet the environmental conditions listed in
Table
Note - When designing environmental control systems such as air conditioning facilities,
confirm that the SPARC M12-1 air intake and the PCI expansion unit air intake meet the
requirements specified in this section.
18 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
Rear service area
Rack
Front service area
(*1)
700 mm
(27.6 in.)
2-4.
800 mm
(31.5 in.)
105 0 mm
(41.3 in.)
900 mm
(*1)
(35.4 in.)