Checking The Component Status - Fujitsu SPARC M12-1 Installation Manual

5.8

Checking the Component Status

This section describes the procedure for checking the configuration, status, and
quantities of the mounted field replaceable units (FRUs).
Execute the showhardconf command.
1.
The command displays all the FRUs mounted in the chassis and their status.
However, it does not display the status of I/O-related components such as PCIe
cards and PCI expansion units while the system power is off.
Example: SPARC M12-1 display example
XSCF> showhardconf -M
SPARC M12-1;
+ Serial:xxxxxxxxxx; Operator_Panel_Switch:Service;
+ System_Power:Off; System_Phase:Cabinet Power Off;
Partition#0 PPAR_Status:Powered Off;
MBU Status:Normal; Ver:3025h; Serial:TZ1710D00R
+ FRU-Part-Number:CA08208-D001 A1
+ Power_Supply_System: ;
+ Memory_Size:64 GB; Type: C ;
CPU#0 Status:Normal; Ver:4242h; Serial:00070592;
+ Freq:3.200 GHz; Type:0x30;
+ Core:6; Strand:8;
MEM#00A Status:Normal;
+ Code:2c800f18ASF2G72PZ-2G3B1
+ Type:83; Size:16 GB;
MEM#01A Status:Normal;
+ Code:2c800f18ASF2G72PZ-2G3B1
+ Type:83; Size:16 GB;
MEM#02A Status:Normal;
+ Code:2c800f18ASF2G72PZ-2G3B1
+ Type:83; Size:16 GB;
MEM#03A Status:Normal;
+ Code:2c800f18ASF2G72PZ-2G3B1
+ Type:83; Size:16 GB;
2. Confirm that no FRU has an asterisk (*) displayed in front of it.
The asterisk (*) is a mark indicating the abnormal state of a FRU, where an error
or degradation occurred.
If a failure has occurred in any unit, see
and
Degradation
3. Execute the showhardconf -u command.
The command displays the quantities of mounted FRUs. However, it does not
display the quantities of I/O-related components such as PCIe cards and PCI
expansion units while the system power is off.
Omitted
"A.2.3 Checking Information on a Component Where a Failure or
Occurred."
;
/9999999
31-1268F2DA;
31-1268F2F9;
31-1268F2DB;
31-1268F2E8;
"A.2.2 Checking the Contents of
Chapter 5 Performing an Initial System Diagnosis
;
Logs"
83