Checking Information On A Component Where A Failure Or; Degradation Occurred; Checking Diagnosis Results - Fujitsu SPARC M12-1 Installation Manual

A.2.3 Checking Information on a Component Where a
Failure or Degradation Occurred
Use the showstatus command to check information on a degraded unit among the
FRUs composing the system.
showstatus command
The command displays information on each unit where a failure has occurred and
the units on higher layers, from among the field replaceable units composing the
system. The mark indicating the status (*) appears at the beginning of the line of the
displayed unit. Status displays the unit status.
Status: Description
■
Faulted: Non-operational status of the relevant component due to failure
■
Degraded: A part of the unit has failed, but the unit continues in operation.
■
Deconfigured: Including its components on the lower layers, the unit is in a
■
normal condition, but it has been degraded due to the influence of a failure or
degradation of another unit.
Maintenance: Maintenance work in progress. The replacefru command is running.
■
Example: Display example where the memory on a motherboard unit is degraded
because of a failure
XSCF> showstatus
MBU Status:Normal;
*
*
*
*
*
*
*
*
A.2.4

Checking Diagnosis Results

Use the testsb command to perform an initial diagnosis of the system hardware.
testsb command
The testsb command diagnoses the hardware configuration and the operation of each
device mounted on the PSB. After completing the diagnosis, the command displays
the results. You can also check the diagnosis results with the display of "Test" and
"Fault" by the showboards command.
The displayed diagnosis results from testsb are as follows:
118 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
MEM#00A Status:Deconfigured;
MEM#01A Status:Deconfigured;
MEM#02A Status:Deconfigured;
MEM#03A Status:Deconfigured;
MEM#10A Status:Deconfigured;
MEM#11A Status:Deconfigured;
MEM#12A Status:Faulted;
MEM#13A Status:Faulted;