Configuring The Ssh Service - Fujitsu SPARC M12-1 Installation Manual

Execute the settelnet command to configure the Telnet service.
2.
The following example specifies that the Telnet service be enabled.
XSCF> settelnet -c enable
Continue? [y|n] : y
Execute the showtelnet command, and confirm that the Telnet setting is
3.
"enabled".
XSCF> showtelnet
Telnet status: enabled
6.3.2

Configuring the SSH Service

Execute the showssh command to display the SSH settings.
1.
The following example displays the SSH service settings. The factory default
setting is "disabled".
XSCF> showssh
SSH status: disabled
RSA key:
DSA key:
Execute the setssh command to configure the SSH service.
2.
The following example specifies that the SSH service be enabled.
XSCF> setssh -c enable
Continue? [y|n] : y
Execute the showssh command to display the host key and fingerprint.
3.
A host key is generated when you enable the SSH service for the first time.
XSCF> showssh
SSH status: enabled
RSA key:
ssh-rsa
AAAAB3NzaC1yc2EAAAABIwAAAIEAt0IG3wfpQnGr51znS9XtzwHcBBb/UU0LN08S
ilUXE6j+avlxdY7AFqBf1wGxLF+Tx5pTa6HuZ8o8yUBbDZVJAAAAFQCfKPxarV+/
5qzK4A43Qaigkqu/6QAAAIBMLQl22G8pwibESrh5JmOhSxpLzl3P26ksI8qPr+7B
xmjLR0k=
Fingerprint:
1024 e4:35:6a:45:b4:f7:e8:ce:b0:b9:82:80:2e:73:33:c4
/etc/ssh/ssh_host_rsa_key.pub
DSA key:
ssh-dss
Chapter 6 Making the Initial System Settings 91