Logging In To The Xscf - Fujitsu SPARC M12-1 Installation Manual

Check the XSCF unit LEDs.
4.
a. The CHECK LED of the XSCF unit goes on for an instant immediately after
b. The READY LED of the XSCF unit flashes during XSCF initialization and
Figure 5-2 Rear of the SPARC M12-1
5.3

Logging In to the XSCF

This section describes the procedure for logging in to the XSCF by using the default
XSCF user account.
Log in to the XSCF by using the default user account and authentication method until
a user account appropriate to the user environment is registered for you. The default
user privileges are useradm and platadm.
Remarks - platadm is mainly used to manage the whole system. useradm is mainly used to
manage user accounts. For details on the user privilege types and the privileges, see
6-3.
After the system management terminal displays "SCF_READY", press the
1.
[Enter] key.
2. After the login prompt appears, enter "default" for the login name.
login: default
After a message prompting operation of the mode switch appears, operate
3.
the mode switch on the operation panel as follows.
a. Switch the mode switch on the operation panel to the Locked position, and
the input power is turned on.
stays on after the initialization completes.
press the RETURN key.
READY
CHECK
XSCF
Chapter 5 Performing an Initial System Diagnosis
Table
77