Sis Configuration And Control; Host Control Port; Establishing A Connection - Extron electronics DTP3 T 202 User Manual

SIS Configuration
and Control
Use Simple Instruction Set (SIS) commands to configure the devices. This section provides
information about using those commands. The following topics are discussed:
•
•
•
•

Host Control Port

The front panel USB-C configuration port can be connected to a host computer for
configuration using SIS commands via an SSH client and IP address (203.0.113.22) on
port 22023.

Establishing a Connection

To establish a network connection to a DTP3 device:
1.
2.
3.
4.
5.
Host Control Port
Simple Instruction Set Control
Using the Command and Response Table
Command and Response Table for SIS Commands
Download the SSH client software from the internet.
Open the SSH client software.
Enter the IP address of the DTP3 device in the Host Name or IP address field.
NOTE: The default IP address is 203.0.113.22.
Enter 22023 in the Port field.
The DTP3 device is password protected, so the appropriate administrator or user name
and password must be entered.
• If the login and password are correct, the device responds with a copyright
message including the copyright year, the name of the product, firmware version,
part number, and the current date and time.
If the login and password are incorrect, the Login as prompt returns. Enter the
•
administrator or user name and password again.
NOTES:
• The DTP3 devices are shipped password-protected. The factory configured
passwords for all accounts on these devices have been set to the device serial
number.
• In the event of a complete system reset, the password converts to the default,
which is extron. New passwords must be configured to secure the device.
• On password-protected connections, there are two levels of protection:
administrator and user. Administrators have full access to all editing functions.
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control 16