Huawei FusionModule800 Quick Manual page 7

4
(Optional) Install the eLight
1. Install the strip light.
1
(1)Strip light extension
cable
(2) ETH converter
3. Install the eLight actuator and power
module.
a. Open the rear door of the end cabinet.
b. Align one end of the support with the notch
on the rear door side of the top panel, and
hook the other end of the support to the
long strip hole on the top panel, as shown
by (1) in figure.
c. Secure the support using two screws at the
notch on the rear door side of the top panel,
as shown by (2) in figure.
4. Connect cables to the eLight system.
2. Interconnect the terminals.
2
6
eLight actuator
eLight power module