Huawei FusionModule800 Quick Manual page 59

3.7
Setting iBOX and iBAT Parameters
1. Choose Monitoring > Power Distribution > iBOX/CIM > Running Parameters.
Parameter
iBOX/CIM single battery
qty.
Batt installation time
Single battery capacity
Current source
Battery string No.
3.8
Networking iBOXs and iBATs in Wireless Mode
1. Press the networking switch on the iBOX for 2 seconds. The ALM indicator blinks red once,
and the RF_Z indicator turns from steady green to blinking green at super short intervals,
which indicates that the iBOX is being networked.
2. Press the iBAT networking switch for 2 seconds. When the RUN/ALM indicator turns from
steady red to blinking green at super short intervals (iBattery 2.0) or short intervals (iBattery
3.0), and finally to blinking green at long intervals, the iBAT connects to the iBOX network.
It is recommended that iBATs be networked from the positive battery string terminal
•
according to the battery cable connection sequence.
• Batteries are numbered depending on the sequence of connecting iBATs to the iBOXs.
3. Perform networking operations on the next iBAT only after networking for the previous iBAT
is successful. Repeat
4. Press the iBOX networking switch for 2 seconds. When the RF_Z indicator on the iBOX turns
from blinking green at super short intervals to blinking green at long intervals, the
networking is complete.
3.9
Commissioning Event Notification
1. Choose System Settings > Event Notification.
2. Set related outbox parameters.
3. Add an email address to receive emails.
4. Add a mobile number to receive event notifications.
5. Set the alarm notification delay parameter and the new alarm notification parameter.
6. Click Confirm to access the re-authentication page. Enter Login password and click Submit.
3.10
Commissioning the eLight
1. Ensure that the device address of the eLight actuator is the default value 2.
2. Choose System Settings> Device Management and click Add Device. The parameters for
adding devices are displayed. Add an eLight.
3. Set eLight parameters.
4. If there are multiple eLights, repeat 1–3.
Description
Total number of batteries
monitored by the iBOX/CIM
Actual time at which batteries are
installed
Single battery capacity refers to the
capacity of a single battery in a
battery string managed by the
iBOX.
0–xxxA Hall
The actual specifications of the Hall
effect sensor prevail.
Set this parameter based on the
planned codes for iBOXs and
battery strings.
2 to add other iBATs to the iBOX network.
Remarks
Set this parameter based on
the battery parameter planned
by the customer.
-
Obtain the battery capacity
from the battery label or
document.
-
Set this parameter based on
the customer's plan.
58