Cafe Wall Assembly - KidKraft WINDALE Installation And Operating Instructions Manual

Step 7: Cafe Wall Assembly
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
A: On the ground lay flat 2 (2215) Posts then loosely attach (2221) Side Ground (in the bottom holes), (1934)
End Floor (in the top holes), (2203) Cafe Side Top and (1935) Side Roof using 2 (H2) 1/4 x 2" Hex Bolts (with
lock washer, flat washer and t-nut) per board as shown in fig. 7.1.
B: Make sure assembly is square and then fasten (2221) Side Ground to (2215) Posts with 2 (S2) #8 x 1-1/2"
Wood Screws and (1934) End Floor to posts with 2 (LS1) 1/4 x 1-1/2" Lag Screws (with flat washer). (fig. 7.1)
C: Tighten all bolts.
Fig. 7.1
Wood Parts
1 x End Floor 1 x 5 x 35-1/4"
1934
1 x Side Ground 1 x 4 x 35-7/8"
2221
2 x Post 2 x 4 x 84-3/8"
2215
1 x Side Roof 1 x 4 x 55-1/8"
1935
1 x Cafe Side Top 1 x 4 x 35-7/8"
2203
1/4" flat
washer
1/4" lock
washer
H2
LS1 1/4" flat
washer
2215
H2
8 x
2 x
2 x
Keep bolts loose.
1935
H2
1/4" t-nut
1934
H2
2221
S2
Hardware
1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H2
1/4 x 1-1/2" Lag Screw (1/4" flat washer)
LS1
#8 x 1-1/2" Wood Screw
S2
23
Assemble Right Wall
Notice shorter end
on this side and
angle facing up.
2203
Notice the hole
locations
LS1
2215