Attach Floor Gussets - KidKraft WINDALE Installation And Operating Instructions Manual

Step 11: Attach Floor Gussets
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
A: Make sure the assembly is square before proceeding.
Assemble Gussets and square fort
B: Measure 4-3/8" down from the bottom of (2211) Floor End, place 1 (0367) Floor Gusset against each (2215)
Post on the Swing Wall at measured location and tight against (2211) Floor End. Attach flush to outside edge of
posts using 1 (LS3) 1/4 x 3" Lag Screw (with flat washer) per post. (fig. 11.1)
C: Attach the other end of each (0367) Floor Gusset to (2211) Floor End with 2 (S2) #8 x 1-1/2" Wood Screws as
shown in fig. 11.1.
Fig. 11.1
S2
x 2 per Gusset
Flush
Wood Parts
2 x Floor Gusset 2 x 3 x 11"
0367
2211
0367
LS3
with 1/4"
flat washer
2215
Swing Wall
2 x
4 x
Hardware
1/4 x 3" Lag Screw (1/4" flat washer)
LS3
#8 x 1-1/2" Wood Screw
S2
27
0367
4-3/8"
Flush