Table of Contents
Advertisement
1. Remove covers.
2. Remove grease from the cylinder rods if coated.
3. Fill the fuel tank. Bleed air from the fuel system. Check all
fluid levels.
4. Adjust alternator and fan belt tension.
5. Check the oil level. Add oil as needed.
6. Install the battery.
If the machine is equipped with the battery disconnect
switch, turn the disconnect switch ON.
7. Start the engine. Run the engine at half speed for several
minutes before full load operation.
8. Repeat the process several times.
9. Stop the engine. Check each device for oil leaks.
10. Replace the fuel filter and engine oil filter with new one
as needed. Change engine oil.
11. Check clamps of the suction hoses, air cleaner hoses and
radiator hoses. Retighten them as needed.
Before operating the machine, thoroughly perform "Daily
Check before Starting the Engine" on page 3-1. Sufficiently
perform the warm up operation.
STORAGE
10-3
Advertisement
Table of Contents
