Towing Pin - Hitachi ZW 310-6 Operator's Manual

Towing Pin

d
WARNING: Since towing is a potentially dangerous
operation, perform only in an emergency situation.
IMPORTANT: Available towing forces by machine model
are as follows. To prevent excessive wear of tires, avoid
towing operation requiring more than the available
towing force.
ZW310-6: 186 kN (19000 kgf) (Power Mode: ON)
ZW330-6: 189 kN (19350 kgf) (Power Mode: ON)
 To ensure safety, always tow the machine at the
speed 5 km/h or less.
 Never tow the machine long distance more than 5
km.
 Do not tow other machine.
Towing pin (2) is located on the rear end of the base machine.
It is used for towing for recovery of machine or fastening the
machine on a trailer deck for transportation. Pull up the left
end, or push down the right end, of stopper (1) to pull out
towing pin (2). Tie or loop the towing rope and let it pass
through the hole.
OPERATOR'S STATION
1-172
1
2
90Z7B-1-135-1EU