Table of Contents
Advertisement
Digital Clock Setting Procedure
In order to set the clock, digital display (7) must be in the
time display mode.
f
NOTE: When the machine battery runs out, the clock
displays [12:00] at the next starting.
Time Adjustment
1. Press display switch (6) to indicate the hour display on
digital display (7).
2. When pressing and holding display switch (6), "Hour"
on digital display (7) will blink. Press UP/DOWN switches
(5) to adjust "Hour". When pressing [UP] key while "12"
is displayed on "Hour" area, it changes to "1". The time is
displayed in 12 hour standard.
3. When pressing display switch (6), "Min." on digital display
(7) will blink. Press UP/DOWN switches (5) to adjust
"Min.". When pressing [UP] key while "59" is displayed
on "Min." area, it changes to "00". However, the "Hour"
display remains unchanged in this case.
4. Press display switch (6) again to end the clock time
setting procedure. Time display stops blinking and
changes to stay ON.
Adjusting Sound
1. Press sound switch (8) several times to indicate the "BAL"
on top of digital display (7).
2. Press UP/DOWN switches (5) to adjust volume balance of
left and right speakers.
When pushing the "DOWN" switch, volume of left
speaker increases; and pushing the "UP" switch, volume
of right speaker increases.
3. Press sound switch (8) several times to indicate the "TRE"
on top of digital display (7).
4. Press UP/DOWN switches (5) to adjust treble.
5. Press sound switch (8) several times to indicate the "BAS"
on top of digital display (7).
6. Press UP/DOWN switches (5) to adjust bass.
7. Tap sound switch (8) to end the sound adjustment
procedure.
f
NOTE: When the machine battery runs out, all of the sound
parameter display [0] at the next starting.
OPERATOR'S STATION
1-141
6
7
5
7
5
MNEC-01-535
MNEC-01-535
8
Advertisement
Table of Contents
