Periodic Replacement Of Parts - Hitachi ZW 310-6 Operator's Manual

Periodic Replacement of Parts

To ensure safe operation, be sure to conduct periodic
inspection of the machine. In addition, the parts listed
below, if defective, may pose serious safety/fire hazards. It is
very difficult to gauge the extent of deterioration, fatigue,
or weakening of the parts listed below simply by visual
inspection alone. For this reason, replace these parts at the
intervals shown in the table below. However, if any of these
parts are found to be defective, replace before starting
operation, regardless of the interval.
Also, when replacing hoses, check the clamps for deformation,
cracks, or other deterioration, and replace as necessary.
Be sure to perform periodic inspection of all hoses, as shown
below, and replace or retighten any defective parts found, as
necessary.
Consult your authorized dealer for correct replacement.
Engine
Brakes
Steering Mechanism
Base Machine
Hydraulic
System
Front
Attachment
Cab
f
NOTE: Be sure to replace seals, such as O-rings and gaskets,
when replacing hoses.
MAINTENANCE
Periodic Replacement Parts
Fuel hose (Fuel tank to fuel pre-filter)
Fuel hose (Fuel pre-filter to main filter)
Oil filter hose (Engine to oil filter)
Heater hose (Heater to engine)
Fuel hose (Engine to fuel tank)
Coolant filter hose (Engine to DCA coolant filter)
Heater hose (Engine to dosing module)
DEF/AdBlue® hose (Aftertreatment device)
Brake valve seals (Rubber parts)
Wet type brake (D-ring for piston)
Accumulator
Stop light switch
Brake hose
Steering hose
Steering cylinder seals (Rubber parts)
Steering valve seals (Rubber parts)
Pump suction hose
Hydraulic hose (Main pump to main valve)
Hydraulic hose (Fan pump to fan motor and fan valve)
Hydraulic hose (Transmission high pressure circuit hose)
Hydraulic hose (Transmission cooler line hose)
Hydraulic oil tank return hose
Hydraulic oil cooler line hose
Hydraulic hose (Valve to hydraulic oil tank return hose)
Lift arm cylinder line hose
Bucket cylinder line hose
Pilot hose
Seat belt
7-13
Replacement Intervals
Every 2 years or 4000 hours
whichever comes first
Every 1 year
Every 4 years
Every 2 years
Every 2 years
Every 2 years or 4000 hours
whichever comes first
Every 2 years or 4000 hours
whichever comes first
Every 4 years
Every 2 years or 4000 hours
whichever comes first
Every 3 years