Table of Contents
Advertisement
Maintenance Guide
Shaded columns in the table indicate maintenance interval.
A. Greasing
Parts
1. Bucket Pin
2. Bucket Link Pin
3. Bucket Cylinder Pin
4. Bell Crank Pin
5. Lift Arm Cylinder Rod Pin
6. Lift Arm Pivot Pin
7. Lift Arm Cylinder Pin
8. Steering Cylinder Pin
9. Steering Cylinder Rod Pin
10. Frame Center Hinge Pin
11. Axle Support Pin
12. Front Propeller Shaft Universal
13. Propeller Shaft Center Support
14. Front Propeller Shaft Universal
15. Front Propeller Shaft Spline
16. Rear Propeller Shaft Universal
17. Rear Propeller Shaft Spline
18. Center Propeller Shaft Universal
: Add grease daily during first 50 hours of operation.
If the machine is engaged in excavation in mud, water or snow, add grease after each work shift.
: After 50 hours of operation, carry out next greasing at the first 250 hours of operation.
Carry out greasing every 500 hours of operation afterwards. Shorten greasing intervals when the machine is
operated under severe conditions or when the machine is continuously operated for a long period of time.
: Shorten greasing intervals when the machine is operated under severe conditions or when the machine is
continuously operated for a long period of time.
IMPORTANT: Grease bucket and link pivots every day until break-in period (50 hours) is complete.
MAINTENANCE
Quantity
10
100
2
2
2
1
2
2
2
2
2
2
2
1
1
2
1
2
1
2
7-14
Interval (hours)
250
500
1000
Page
2000
4000
7-27
7-27
7-27
7-27
7-27
7-28
7-28
7-28
7-28
7-29
7-29
7-29
7-30
7-30
7-30
7-31
7-31
7-31
Advertisement
Table of Contents
