Table of Contents
Advertisement
1.2 Standards
1.2.1 Applicable standards
The listed standards are valid at the time of the release of this document. Phased
out or replaced standards are removed from the list when needed.
Standards, EN ISO
The product is designed in accordance with the requirements of:
Standard
EN ISO 12100:2010
EN ISO 13849-1:2015
EN ISO 13850:2015
EN ISO 10218-1:2011
ISO 9787:2013
ISO 9283:1998
EN ISO 14644-1:2015
EN ISO 13732-1:2008
EN 61000-6-4:2007 +
A1:2011
IEC 61000-6-4:2006 +
A1:2010
(option 129-1)
EN 61000-6-2:2005
IEC 61000-6-2:2005
EN IEC 60974-1:2012
EN IEC 60974-10:2014
EN IEC 60204-1:2006
IEC 60529:1989 + A2:2013
IEC 61340-5-1:2010
i
ii
Product specification - IRB 1200
3HAC046982-001 Revision: G
Note
Description
Safety of machinery - General principles for design - Risk as-
sessment and risk reduction
Safety of machinery, safety related parts of control systems -
Part 1: General principles for design
Safety of machinery - Emergency stop - Principles for design
Robots for industrial environments - Safety requirements -Part
1 Robot
Robots and robotic devices -- Coordinate systems and motion
nomenclatures
Manipulating industrial robots, performance criteria, and related
test methods
i
Classification of air cleanliness
Ergonomics of the thermal environment - Part 1
EMC, Generic emission
EMC, Generic immunity
ii
Arc welding equipment - Part 1: Welding power sources
ii
Arc welding equipment - Part 10: EMC requirements
Safety of machinery - Electrical equipment of machines - Part
1 General requirements
Degrees of protection provided by enclosures (IP code)
Protection of electronic devices from electrostatic phenomena
- General requirements
Only robots with protection Clean Room.
Only valid for arc welding robots. Replaces EN IEC 61000-6-4 for arc welding robots.
© Copyright 2017 ABB. All rights reserved.
1 Description
1.2.1 Applicable standards
Continues on next page
17
Advertisement
Table of Contents
