Table of Contents
Advertisement
•
Keep key fobs away from children.
Operation of the Remote Start
System, windows, door locks or
other controls could cause serious
injury or death.
Engine Remote Start Abort
Message on Instrument Cluster
The following messages will display
on the instrument cluster if the vehicle
fails to remote start or exits remote
start prematurely:
• "Remote Start Canceled Door Open".
• "Remote Start Canceled Liftgate
Open".
• "Remote Start Canceled Fuel Low".
• "Remote Start Canceled Time
Expired".
• "Remote Start Disabled Start Vehicle
to Reset".
The message on the instrument cluster
stays active as long as the ignition
device is in RUN position.
To enter Remote Start Mode
NOTE:
On some versions, the remote start
button
on the key fob is replaced
by the
button.
Press and release the button
the key fob twice within five seconds.
The vehicle doors will lock, position
lights will flash and the horn will ring
twice (if the "Sound Horn with Remote
Start" function of the "Doors & Locks"
submenu is activate using the MIA
System, refer to "Functions of Settings
Menu on MIA" in section "Dashboard
Instruments and Controls"). Then, the
engine will start and the vehicle will
remain in the "Remote Start" mode
for a 15-minute cycle.
NOTE:
• In case of an engine fault or low fuel
level, the vehicle will start and then
shut down in 10 seconds.
• The position lights will turn on and
remain lighted up during "Remote
Start" mode.
• For security reasons, power window
and power sunroof operation (if
on
equipped) are disabled when the
Starting and Driving
vehicle is in the "Remote Start"
mode.
• The engine can be started two
consecutive times (two 15-minute
cycles) with the key fob. However,
the ignition device must be cycled
to the RUN position before you can
repeat the start sequence for a third
cycle.
To exit Remote Start Mode
without Driving the Vehicle
Press and release the button
time or allow the engine to run for the
entire 15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the
system will disable the one time press
of the button
for two seconds
after receiving a valid "Remote Start"
request.
To exit Remote Start Mode and
Drive the Vehicle
Before the end of the 15-minute
cycle, press and release the button
on the key fob to unlock the
doors and disarm the vehicle security
alarm. Then, prior to the end of the
15-minute cycle, press and release the
START/STOP button.
one
5
167
Advertisement
Table of Contents
