Table of Contents
Advertisement
4-12 | Thermox Series 2000 WDG Insitu Analyzer
Communication
Define RS-485 communications parameters between the Series 2000 con-
trol unit and a host device. This includes the following:
Baud Rate
Allows you to define the baud rate that the control unit and the
host computer are using to communicate. Choices are 300,
600, 1200, 2400, 4800, and 9600 baud.
Node Address
Allows you to define the physical address for the control unit
(between 0 and 255) on a network so the host computer can
identify the control unit if using network communications (see
below). Note that each control unit must be assigned a unique
address; otherwise, communication results will be unpredict-
able.
Allows you to temporarily disable control unit serial communi-
Enable Serial
cations.
Advertisement
Table of Contents
Troubleshooting
