Sensor Connections - Ametek Thermox WDG Insitu User Manual

Figure 3-18. sensor board.
3-18 | Thermox Series 2000 WDG Insitu Analyzer

sensor Connections

Make sure that power has been removed from the control unit and
sensor before making sensor connections. See Figure 3-18, Sensor
Board.
This section describes required wiring connections between the control unit and
the sensor. Follow the connection instructions for the applicable options for your
analyzer. All sensor connections require that you access the sensor board (see
Figure 3-18).
Sensor cabling must be twisted pairs in an overall braided shield, or

twisted pairs in rigid metal conduit. Follow all wiring guidelines as
specified in Figure 3-17 in the front of this wiring section.
NOTE
Connections
to Controller
Connections
to Sensor
AC Line Power
Sensor
Board