Option Card Installation; Removing Display Module Or Power Supply/Keypad Module - Ametek Thermox WDG Insitu User Manual

option Card Installation

Figure 3-25. Front view of series 2000 control unit.
3-30 | Thermox Series 2000 WDG Insitu Analyzer
This section shows you how to add option cards to the control unit. This includes
the following option cards:
•
Combustibles Card - requires combustibles detector in sensor
•
Auto Calibration Card - requires remote calibration unit
If you ordered any of these options when you purchased your analyzer, these
option cards will already be installed in the control unit. This section shows you
how to install an option card if you later add that option to the control unit.
This section also shows you how to access the display module and power supply/
keypad module on the control unit in case you need to replace these modules or
change a component in them (for example, install new software).
Removing Display Module or Power supply/Keypad
Module
This section describes how to remove or replace the display module or power
supply keypad module on the control unit (see Figure 3-25):
Remove power from the control unit before working on it.