Table of Contents
Advertisement
Figure 7-5. Cell and retainer clip placement. (Inset) Retaining clip detail.
18. Slide the heater into the inner probe assembly until the marks you
placed on the heater in Step 2 of the removal section align with the
U-bolt. Tighten the U-bolt using a 3/8" nut driver.
19. Reinstall the probe into the process by reversing the steps of the "Re-
moving the Inner Probe Assembly" section in this chapter.
20 Perform a primary calibration.
Service and Parts | 7-9
Advertisement
Table of Contents
Troubleshooting
